IMPORTANT: When you drill out the fire resistant caulking from the mounting hole bushings you must mount the safe to the floor using the lag bolts and gasket washers. For a masonry floor drill 7/16" diameter x 2-1/2" deep pilot holes for the anchors. Drill pilot holes in the floor as follows: For a wood floor drill 5/16" diameter x 2-1/2" deep pilot holes. Continue to use this drill to mark the hole location on the floor. Use a 3/8" diameter drill bit to drill out this caulking. These bushings are filled with fire resistant caulking which must be drilled out before mounting the safe to the floor. Lift the carpeting up and locate the mounting hole bushings. Failure to do so will void the fire and waterproof ratings. You must remove the safe from the skid and place the safe on the floor. Failure to do so will void the waterprooof rating. The safe must be fastened to the floor using the lag bolts and gasket washer provided with this safe to insure the waterproof rating. As the water level rises, the safe will begin to float and could fall over causing personal injury. WARNING: Because this safe is waterproof it will float. For greater security the safe should be located in a corner and fastened to the floor. Do not mount the safe to a wall using these vent hole. Do not drill through the insulation in the rear vent holes. Do not drill holes in the safe for electrical dehumidifying devices. For extra humidity control we recommend the use of a desiccant. Your safe should be installed in an isolated, dry and secure area. You will have 5 seconds to turn the handle before the locking mechanism is reactivated. After you have entered the factory code, you will need to turn the handle clockwise to open the door. You should change the entry code as soon as possible after opening the safe to insure proper security). To open an electronic lock the first time, press the following numbers/symbols on the electronic keypad in this order: 1, 5, 9, #. You must first install the battery which is located in the front protective styrofoam (See BATTERY REPLACEMANT below) NOTE: Do not use this handle to move the safe. These spokes are located in the front foam packaging. Screw the 5 handle spokes into the hub and hand tighten. This material will not survive the rated internal temperature of the safe. Do not store electronic media, computer disks, audio-visual media or photographic negatives in this safe.NOTE: Stack-On is not responsible for any cost incurred if the safe is replaced due to a flood.Children could accidentally be locked inside the safe. Warning: Keep your safe closed and locked at all times.Removing the back panel on the door will void the fire rating.The handle should only be used for opening and closing the door of the safe. Do not move this safe using its handle.Do not store trouble key or this document in the safe. Keep keys and combination in a secure place away from children.Record the serial number from the tag on the back of the safe or from the tag on the front bottom corner of the safe.Only you will have access to this information. Storing your Key # or Combination will provide instant access to this important information should you ever lose your keys or your combination. NOTE: You can store your Key #, Serial # and Combination on Stack-On’s SECURE web site – under Service. Or serious injury to children and adults.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |